How To Install My Panels: Aluminum or Clear
Start by placing panels and hardware at the appropriate windows and/or opening. Always start at the left side of the window. Feed the slider bolts included in your hardware into the bottom track. The size of the window will determine how many are needed. Start with at least 6. Then place the panel labeled 1 on the far left side. Align the bolts with the holes at the bottom of the panel. Since the panels overlap, only wingnut the first two bolts. Do not tighten all the way. With the panel labeled 2, insert it overlapping the first panel. Once again, line up the holes with the bolts and wing nut the next two bolts. Do not tighten all the way. Keep inserting panels until the window is complete. On the last panel, tighten all the bolts. But not all the way. At this time, if the panels need to be shifted right or left this is the time to do so. Once the panels are completely covering the window, tighten all of the wing nuts. However, they only need to be finger tight. Do not over tighten or they will be hard remove. This could possibly breaking your wingnuts or damaging your panels, which we are not responsible for. Please feel free to Contact Us with any questions.
How To Install My Storm Catcher:
Start by placing your screens or fabric by the appropriate window or opening. For Storm Catcher make sure the white tag with your name on it is in the lower right hand corner. For Fabric Shield the writing should be on the inside of panel. Starting at the left top side, hang the material on the male panel mates and loosely put on the wingnuts. Once the top is attached and hanging, start fastening the sides and bottom. Make sure you do not tighten the wingnuts and bolts fully until they are all in place. Do not over tighten or force your hardware or it will be hard to remove and may possibly damage your anchoring system, which we are not responsible for. Tighten side sidewalk bolts with a # 3 screw driver or with a screw gun on a very low setting using a # 3 bit. Lubricate sidewalk bolts with white lithium lubricate as needed. Please feel free to Contact Us with any questions.
How To Install My Fabric Shield:
